Having problems with your new led's flickering, flashing, showing bulb errors on your dashboard, not working at all ?
What you need are load resistors, this Auction is for a pair of load resistors to help sort out the problems above.
What do they do ?
Basically led's have a resistor hidden within the bulb to bring the normal 12v auto voltage down to 3 to 4v so they don't pop.
On new cars manufactured after 2002 adopting the Can-Bus wiring system these led's may show signs of problems mentioned above, this is known to cause problems with Audi, BMW, Bentley, Porsche, Mercedes and other makes and models too.
Load resistors take the left over voltage and turn it into heat rather than light and solves the problems incurred earlier.
They do take a little DIY fitments, which involves attaching one end of the resistor wire to the positive terminal of your bulb holder and one end to the negative side of the bulb holder.
Please note that these load resistor will get very hot, take care when mounting them that they are away from anything that they may cause damage to.
These load resistor will work with the following car leds: -
501, T10, T4W, H6W, 31mm 36mm 39mm 44mm Festoon etc
Specification
25w Load Resistors
10 Ohm
Includes 4 x free scotch blocks for connection to wiring.
